Push grout into the joints by first moving the float in line with the joints then diagonal to them.
Materials needed to tile a floor.
Mortar usually comes in two varieties pre mix and unmixed mortar that comes in a box.
Our floor required 1 4 in thick backer.
Floor tile installations require both common and tile specific tools.
Wet tile saw or snap tile cutter.
If a straight cut edge shows rub it against a sheet of 80 grit aluminum oxide sandpaper to round and smooth the edge.
Add water a little at a time by squeezing it from a sponge.
With joists every 24 in you need 1 1 2 in.
Thin set is cement based but some mortars are labeled as non modified and require a latex polymer admixture that will improve the performance of the mortar and increase bond strength.
Use tile nippers or pliers to nibble off the uneven edge of a broken tile.
Scoop a trowelful of grout onto the floor and spread it with a rubber float held at a 45 degree angle to the floor.
Setting tile is fairly straightforward if you begin in the center of the room and work your way out this guide shows you how to work with mortar lay out and level tiles and score tiles to complete a professional looking installation.
Yours might need 1 2 in.
You need a few easily accessible tools such as a tape measure a chalk line and a level.
Mix up a batch of grout to a looser than mayonnaise consistency.
Before you zip off to the hardwarestore to spend a lot of money take a moment to think about your required tool list.
Use a round file to smooth rough edges of areas that have been nibbled away.
If your floor is too thin for tile add a thicker layer of tile backer board.
When it comes to installing a tile floor you will need a rubber mallet spacers a level a tile trowel and thin set or another type of mortar.
If you want to tile like a professional then check out our rundown of the 10 essential tools and materials for tiling.